How to make Cat5,Cat5e,Cat6 networking cable

First you need to prepare the following accessories:

Cat5 or Cat5e or Cat6

Bulk RJ45 Crimpable Connectors

RJ-45 Crimping tool


There are two kinds of Ethernet cables you can make. Straight Through and Crossover. STRAIGHT THROUGH - Ethernet cables are the standard cable used for almost all purposes. It is suggest you duplicate the color order as shown below. Note how the orange pair is not alongside as are all of those other twos. This setup allows for longer cord runs.

CROSSOVER CABLES -- The intention of a Crossover Ethernet cable  is to directly connect one computer to another computer (or device) without going through a router, switch or hub.

Action 1: Here's how to make a standard cable: cut into the plastic sheath 1 inch from the end of the cut cable.


Step two: Unwind and pair of the similar colors.

3: Crunch the wires regarding the fingertips and straighten them out as shown. (The cord colors make to form a straight through standard cat 5 cable as described above. )
Step four: Use scissors to create a straight cut across the wires 1/2 Inch from the cut sleeve to the end of the wires.
Step 5: Push the wires into the connector. Note the positioning of the blue plastic safeguarding. Also note how the wires go right to the end.


Step 6: CRIMPING THE CABLE... carefully place the connector into the Ethernet Crimper and piece of cake down on the handles securely. The water piping splicing tabs on the connector will pierce into all the eight wires. May locking bill that holds the blue plastic sleeve in place for a tight data compresion fit. When you remove the cable from the crimper, the cable is just about to use.

Step 7: Make sure to test the cables before installing them. An inexpensive Ethernet cable tester does this quite nicely.
Related:
http://zerolang.exteen.com/20130412/the-way-to-make-cat5-cat5e-cat6-networking-cable
http://edfa1.blog.fc2.com/blog-entry-120.html

http://www.10gmodule.com/sitemap.xml